Ositech comm 614006-001 - Manual (Page 27)

User’s Guide and Reference 3 - 7
Operation
For an OS/2 workstation you must first install LAN Adapter and
Protocol Support (LAPS) and then import the Trumpcard driver.
1. Follow the instructions for installing LAPS in
accordance with your IBM LAN Adapter and Protocol Support
Configuration Guide. You must first install LAPS on the
workstation in order to install additional Network adapter
drivers.
2. Issue the LAPS command from the IBMCOM subdirectory of
the drive that contains the copy of LAPS.
3. Select ‘INSTALL’ from the LAPS logo window.
4. When prompted for the source path of additional Network
drivers enter, A:\OS2. Insert the Trumpcard driver diskette into
Drive A.
5. Select ‘Configure’, then select ‘Configure LAN Transports’,
and then select ‘Continue’.
6. Remove any existing adapters and protocols from the Current
Configuration menu that are not required.
7. Select ‘Ositech Trumpcard’ adapter from the Network
Adapters menu and then select ‘Add’.
8. Add the required protocols from the Protocol menu, and finally
select ‘OK’ when complete.
After installation of the Trumpcard NDIS device driver and protocols,
you must install the needed requester (DOS or OS/2) to complete the
installation.
The following are examples of changes made to the CONFIG.SYS and
PROTOCOL.INI files on an OS/2 workstation installation.
CONFIG.SYS
DEVICE=C:\IBMCOM\LANMSGDD.OS2 /I:C:\IBMCOM
DEVICE=C:\IBMCOM\PROTMAN.OS2 /I:C:\IBMCOM
RUN=C:\IBMCOM\PROTOCOL\NETBIND.EXE
RUN=C:\IBMCOM\LANMSGEX.EXE
DEVICE=C:\IBMCOM\PROTOCOL\NETBEUI.OS2
DEVICE=C:\IBMCOM\PROTOCOL\NETBIOS.OS2
DEVICE=C:\IBMCOM\PROTOCOL\LANDD.OS2
DEVICE=C:\IBMCOM\PROTOCOL\LANDLLDD.OS2
DEVICE=C:\IBMCOM\MACS\OTCETH.OS2
RUN=C:\IBMCOM\PROTOCOL\LANDLL.EXE