Ositech comm 614006-001 - Manual (Page 23)

User’s Guide and Reference 3 - 3
Operation
Network Software Installation
In order to assist with the installation and configuration of networks
drivers, Ositech has provided Installation Software for the DOS / Windows
and OS/2 operating systems. Follow the instructions printed on the
appropriate diskette label for details on how to invoke the Installation
Software. For operating systems other than DOS / Windows and OS/2,
please refer to the appropriate section for instructions on how to install
and configure the Network driver under these operating systems.
The following sections provide details on how to install and configure the
Trumpcard Ethernet Network drivers. The Network operating systems
have been listed alphabetically.
Note: If the Trumpcard you are using provides other functions in addition to
Ethernet networking, please refer to the Installation Manual
accompanying the Trumpcard for details on how to operate the
functions simultaneously.
Banyan VINES
To install Banyan VINES version 4.x and later on a DOS NDIS workstation,
you must manually install the Ositech Trumpcard NDIS device driver.
1. Follow the instructions for workstation installation
in accordance with your Banyan VINES workstation installation
manual.
2. At this point you should have all the relevant Banyan VINES files in
a directory on your hard disk drive. (In this manual we will assume
that the Banyan Vines directory is called \VINES).
3. Copy the files PROTOCOL.INI and OTCETH.DOS from the
\VINES directory on the Trumpcard driver diskette to the
Banyan VINES directory.
(i.e. COPY A:\VINES\OTCETH.DOS C:\VINES )
4. Use an ASCII text editor and edit the CONFIG.SYS file to include
the following lines:
DEVICE=C:\VINES\PROTMAN.DOS /I:C:\VINES
DEVICE=C:\VINES\OTCETH.DOS
(The command to edit the file is EDIT C:\CONFIG.SYS )
5. Change to the \VINES directory.