Opticon LPN 1736 - Manual (Page 10)

Manual No. 25-ULPNMU01-01 LPN1736 Omni-Directional Laser Scanner
Reset All Defaults
Opticon scanners are preprogrammed at the factory with default settings representing the
settings most commonly used by our customers. In most applications, the scanner will
work right out of the box without the need for additional programming. At any time, you
can return a scanner to the factory defaults by scanning the “Start/Stop Programming
Mode” bar code, then scanning the “Reset All Defaults - Wedge” programming bar code,
followed by scanning the “Start/Stop Programming Mode” bar code again.
[[
Start/Stop Programming Mode
Scanning this programming bar code puts the scanner into the programming mode. The
scanner will beep continuously indicating that it is in programming mode. In this mode
the scanner will only read special programming bar codes. It will not read regular bar
codes. Now you can scan the specific programming bar code(s) you desire. Finally scan
the Start/Stop Programming again. This instructs the scanner to exit the programming
mode. The beeps will stop. The scanner is now ready to read regular bar codes.
Keyboard Type Selection
VC
Reset All Defaults to IBM AT Keyboard Wedge (UB)
The IBM AT style of keyboard is the default setting for this scanner. If your keyboard
style is different scan the appropriate programming codes that follow:
Page 10