Omega DPF500 Series - Manual (Page 12)

8
4.2 Programming Flowchart
RATE RA RA
TOTAL
CLR ToT
FDEC
12345678
M
RUN MODE
CLEAR TOTAL OT OT
FACTOR
DECIMAL
FAC
100
FACTOR
0000
ent Code
ENTER CODE
If panel
lock ON
If panel
lock OFF
If code
correct
If code
incorrect
FAC
20poInt
FACTOR
TYPE
20poInt
lInear
lInear
selected
E
M
E
E
M
E
M
E
M
20poInt
selected
Continue On
Next Page
Fr#
#####
FREQUENCY
for POINT #
(Fr0-Fr19)
FaC#
#####
FACTOR for
POINT #
(FAC0-FAC19)
If Fr1-FR19 = 0
# = 19
E
M
E
M
YES
SET pnts
E
M
YES
No
SET
20PT
YES
selected
No
selected
Press the M key to enter the programming menu.
The SET pnts prompt will only appear if 20point is selected. This allows users
to bypass the 20 point set up and keep the existing values.
Press the key to choose YES or NO.
Press the E key to enter the displayedselection.
Press the M key to skip (same as selecting NO).
If the panel lock is on, you must enter the 4 digit lock code to gain access
to the menu.
Press the key to increment each individual digit of the code.
Press the
key to advance to the next digit.
Press the E key to enter the displayed code.
If the code is correct, display advances to "
clr tot", if not, display returns
to run mode
Press the E key to clear the totalizer and return to the programming menu.
Press the M key to skip and go to next menu item.
Press the key to step the factor decimal to the desired location.
Press the E key to enter the displayed decimal location.
Press the M key to skip and keep the existing location
NOTE: For best performance and resolution choose as many decimal places as
possible in the K-Factor.Example: Enter a K-Factor of 1 as 1.000.
Press the key to choose factor type ( 20point or linear).
Press the E key to enter the displayed factor type.
Press the M key to skip and keep the existing factor type.
Press the key to increment each individual digit of the factor for point #.
Press the
key to advance to the next digit.
Press the E key to enter the displayed factor.
Press the M key to skip and keep the existing factor.
If 0 is entered, the display will advance to the next prompt (tdec).
Press the key to increment each individual digit of the frequency for point
#.
Press the key to advance to the next digit.
Press the E key to enter the displayed frequency.
Press the M key to skip and keep the existing frequency.
If 0 is entered, the display will advance to the next prompt (tdec).
NOTE: Frequency/factor point pairs must be entered in ascending order of fre-
quency
The FAC prompt will only appear if linear is selected or if the unit was ordered
without the 20 point linearization option.
Press the key to increment each individual digit of the factor.
Press the
key to advance to the next digit.
Press the E key to enter the displayed factor.
Press the M key to skip and keep the existing factor.