Omega Vehicle Security OMG-ULTRACOMM2-PCI RS-232 - Manual (Page 14)

Installation
Omega Engineering OMG-ULTRA COMM+2.PCI Page 10
Installation
Operating System Installation
DOS
Refer to the ‘PCI.txt’ file found in the \DOS\PCI sub-directory on the supplied
Serial Utilities Diskette.
Windows 3.1x
Refer to the Win3x.hlp file found in the \Windows\3.1x sub-directory on the
supplied Serial Utilities Diskette.
Windows 95
Refer to the PCI.hlp file found in the \Windows\95 sub-directory on the supplied
Serial Utilities Diskette.
Windows NT
Refer to the PCI.hlp file found in the \Windows\NT sub-directory on the supplied
Serial Utilities Diskette.
Hardware Installation
The OMG-ULTRA COMM+2.PCI can be installed in any of the PCI expansion
slots and contains several jumper straps for each port that must be set for proper
operation.
1.
Turn off PC power. Disconnect the power cord.
2. Remove the PC case cover.
3. Locate an available PCI slot and remove the blank metal slot cover.
4. Gently insert the OMG-ULTRA COMM+2.PCI into the slot. Make sure that
the adapter is seated properly.
5. Replace the screw.
6. Replace the cover.
7. Connect the power cord.
Installation is complete.