Onkyo PHC-5 - Manual (Page 6)

6
Installation (continued)
Installation Precautions
Install the unit on a level, stable surface. The unit may fall if you install it on a tilted or unstable surface.
Follow the requirements below to place the unit on top of a TV:
•
The TV surface on the top side is larger than the bottom surface of the unit.
•
The TV surface is level and not tilted.
•
The TV is not on an unstable surface.
To prevent the PHC-5 from falling, be sure to attach the anti-slippage pads (included in the package) on the bottom of the unit,
and use a strong rope to fix the unit against the wall for safety, as shown in the figure.
If you cannot fix the unit using a rope, attach the dual-sided fixing tape (included in the package) to the bottom of the PHC-5 to
fix the unit to the TV.
Note 1: The dual-sided fixing tape (white) uses strong adhesive. It will be very difficult to remove the tape once it is attached to
the surface.
Note 2: Make sure that the surface on which you wish to attach the anti-slippage pad or tape is not dirty or wet. Otherwise, the
pad or tape will not be fixed to the surface.
Anti-slippage pads
● Attaching anti-slippage pads or dual-sided fixing tape
Attach the included anti-slippage
pads in the left and right corners
on the bottom of the unit as
shown in the figure. If the unit
can not be secured with the pads,
attach the dual-sided fixing tape
on top of the pads.
Bottom of the unit
Anti-slippage pads (black)
Dual-sided fixing tape (white)
Secure the unit against the wall using a
strong rope to prevent the unit from falling.
(Be sure to secure the unit against the wall
at two places.)
TV
Do not place the unit in the following
locations:
Where the width of the TV
is narrower than the unit.
Where the vent holes on the
bottom of the unit are blocked.
Where the top surface
of the TV is tilted.
Use this slot to
tighten the rope.
PHC-5
Wall