28 using the radio, Listening to the radio tuning the radio – Onkyo CR-505DA User Manual
Page 28
28
Using the Radio
1
Press the [AM] or [FM] button to select AM
or FM. Or use the [INPUT] button, or the
remote controller’s INPUT [ ]/[ ] buttons
to select AM or FM.
1
Press and hold the TUNING [
] or [
]
button on the remote controller for more
than one second and then release it.
The CR-505DAB searches for the next station. Search-
ing stops when a station is found.
2
Use the TUNING [
]/[
] buttons for fine
tuning.
Note:
You can tune the radio with the remote controller only.
If you select the FM band:
When you’re tuned into a station, the Tuned
and “ST’
(FM stereo) indicators appear.
The FM band is searched in 0.05 MHz intervals.
If you select the AM band:
When you’re tuned into a station, the Tuned
indicator
appears.
The AM band is searched in 9 kHz intervals.
■
Tuning into weak FM stations
If a station has poor signal strength, you may not be able to
tune into that station properly, or reception may be noisy. In
this case, switch the FM Mode to Mono, then tune the band.
Switching the FM Mode to Mono:
1
Press the [MODE] button.
2
Use the [
]/[
] buttons to display “FM
Mode” and press [ENTER].
3
Use [
]/[
] to display “Mono” and
press [ENTER].
The “ST” (FM stereo) indicator goes off and mono
mode is selected.
Using the buttons on the CR-505DAB:
1. Press the [MENU] button.
2. Turn the [
] control until “FM Mode” appears on
the display and push the [
] control.
3. Turn the [
] control until “Mono” appears on the
display and push the [
] control.
Listening to the Radio
Tuning the Radio
AM
FM
DAB
DIRECT
TAPE
CD
MD
MUTING
--/---
7
8
9
10/0
4
5
6
2
3
1
CLOCK
CALL
TIMER
CLEAR
REPEAT
DISPLAY
SLEEP
MODE
ENTER
INPUT
STANDBY/ ON
INPUT /
ENTER
MODE
AM
FM
PRESET /
TUNING /
STANDBY / ON
INPUT
MENU
BASS
TREBLE
PUSH TO ENTER
PRESET
DIRECT
PHONES
VOLUME
MIN
MAX
/
MENU
INPUT
/
/
/
/