OWI AMP-IC5 User Manual
Page 15
Filename:AMPIC5_6 MANUAL
07/18/08
Page 15 of 16
Attach the speaker wires to the speaker terminals.
Insert your OWI speaker into the opening and tighten the four screws. As you tighten the screws, the tabs will
automatically flip into an outward position thereby clamping the drywall between the feet and the flange of the
speaker. BE CAREFUL NOT TO OVER TIGHTEN, OVER TIGHTENING MAY WARP THE BAFFLE,
CRACK THE WALL, CAUSE THE FLANGE TO DISTORT AND MAKE THE GRILL DIFFICULT TO
INSTALL.
Push the grille firmly into the slot in the speaker baffle.
Painting your OWI Speakers
The speakers' other surfaces are primed to accept ordinary latex wall paint or aerosol spray paint. The surface of the
speaker behind the grille should remain black and must not be painted. It is necessary to mask this area with the
center of the template that you have cut out.
The grille can be painted as well, but great care must be taken not to clog the holes in the grille as this will
greatly reduce the sound quality of the speakers. It is recommended that only light spray painting using 5 parts
thinning agent to 1 part paint be used. Do not paint the grilles while they are attached to the speaker.
Proper Wire Gauge Selection
The gauge of wire required is determined by the distance between your amplifier/receiver and the speakers. Use
the following chart as a guide:
OWI INC.
17141 KINGSVIEW AVENUE
CARSON, CA 90746
TEL: 310-515-1900 FAX: 310-515-1606
www.owi-inc.com
Length Minimum
Gauge
Less than 10 feet
18 - 20 Gauge
10 to 100 feet
16 to 18 Gauge
Over 100 feet
14 Gauge