Opticon OPL 9712 - Manual (Page 15)

Opticon
OPL 9712
Specifications Manual
15
9. Interface Specifications
9.1. Bluetooth Specifications
Bluetooth® is a registered trademark owned by its proprietor and used by
OPTOELECTRONICS Co., Ltd. under license.
Feature Description
Version 1) 2.0
Supported protocol stack 1) RF (Radio Frequency Protocol)
BB (Base Band Protocol)
LM (Link Manager Protocol)
L2CAP (Logical Link Control and Adaptation Protocol)
SDP (Service Discovery Protocol)
RFCOMM (serial port emulation)
Supported profile 1) SPP (Serial Port Profile)
DUN (Dial-up Network Profile)
Communication configuration 2) 1 to 1 – one OPL 9712 to one host system
(Do not connect multiple scanners to one host system.)
Scanner operating mode while
connected to the host system Master or Slave mode
Security mode Authentication enabled: These settings can be configured using menu
barcodes.
Encryption Encryption is linked to the authentication setting and cannot be
enabled or disabled separately.
Communication range 3) Approximately 10 meters
Frequency 2400 MHz to 2483.5 MHz
Transmission power 2.5mW (4dBm) or less
Comm. range 10 m
Baud rate 115.2 kbps
Antenna 1/4λ (surface mounted)
Notes
1. The OPL 9712 complies with Bluetooth standards. The device that communicates
with the OPL 9712 must support the same SPP. For other Bluetooth devices with
other profiles we cannot guarantee a connection before the products have been
tested.
2. The communication speed and range of the OPL 9712 may vary due to obstacles
and radio wave conditions between the OPL 9712 and the device to which the
OPL 9712 is connected. Conditions on the host device may also affect the
communication speed and communication range of the OPL 9712.
3. The prospective distance may vary based on environmental characteristics. Also
note the following frequency description.