One for All URC10820N - Manual (Page 3)

3
Key Charts
The LED (red light), which is
located underneath the POWER
Key, blinks to show that the
remote control is working and
is sending signals.
Press TV, CBL, SAT, VCR,
DVD, CD, PVR, AUD, AUX1 or
AUX2 once to select a desired
home entertainment device to
control.
Press POWER once to turn
on or off the selected device.
For master power control, see
“Programming a Master Power
Macro.”
Press MENU once to display
your selected device’s main
menu.
Use GUIDE to display your
selected device’s program guide
or setup menu.
Use EXIT to exit from your
selected device’s guide or menu.
Use INFO to display the
current channel and program
information.
Use the Cursor Keys to move
the cursor in the program guide
and menu screens.
Use OK to choose options from
your selected device’s menu or
guide. In the RCVR/AMP mode,
use OK to set the surround
sound. Use the up arrow (or
down arrow ) to adjust the
volume higher (or lower).Use
the left arrow (or right arrow)
to adjust the balance left (or
right).
Use VOL + (or VOL -) to raise (or lower) the sound volume.
Press MUTE once to turn the sound off or on.
In TV, VCR, DVD, CBL, or SAT modes, use FAV to scan favorite
channels and/or all channels. (See “Using Channel Scan” and
“Programming Favorite Channel Scan.”)
Use CH + (or CH -) to select the next higher (or lower) channel.
Press PREV once to recall the last-viewed channel and to page back
one screen on the main menu. In the AUD, DVD and CD modes, use
DISC to change disk (if available on your device).
Use the keypad (1 ~ 9 and 0) to directly select channels (e.g., 009 or
031). In the AUD mode, use the keypad (1 ~ 9 and 0) to select audio
sources 1 through 10.