Oregon Scientific IB368 - Manual (Page 8)

8
USING THE TRANSMITTER DOCK ADAPTER
1. Connect the AC adapter connector into the DC IN
9V / 800mA jack at the back of the transmitter dock.
2. Plug your AC adapter into an electrical socket.
NOTE Always use the supplied AC power adapter that
is designed specifically for the transmitter dock only.
Using any other AC power adapter may cause the unit
to malfunction and increase the risk of fire or injury.
NOTE Should you notice any abnormality in the
transmitter dock AC adapter, disconnect it from the
electrical socket and transmitter dock immediately and
take it to a qualified Oregon Scientific dealer for servicing.
DOCKING THE iPOD
The transmitter dock acts as a docking station for
different versions of the iPod:
1. Insert the appropriate docking tray intended
specifically for use with your iPod model into the
transmitter dock.
TIP View the engraving at the bottom of each tray, which
contains an iPod description and / or size of internal
hard disk to ensure that you correctly match the
appropriate tray for your iPod.
2. Insert the iPod into the docking tray. Make sure to
align the docking tray’s connectors with the iPod
connection slot.
If batteries run low on power and AC adapter is plugged
in:
WALL MOUNTING THE SPEAKER
(OPTIONAL)
The speaker is equipped with rubber supports to give
your unit a stable base while placed on a flat surface.
NOTE Placement of this product on wood surfaces with
certain types of finishes, such as clear varnish, may
result in damage to the finish. Consult the furniture
manufacturer’s care instructions for direction as to the
types of objects that may safely be placed on the wood
surface. Oregon Scientific shall not be responsible for
any damage to wood surfaces from contact with this
product.
Fix the location of your speaker against the wall using
the supplied allen key, L-shaped wall-mount unit and 4
screws:
1. Position the wall-mount unit’s vertical panel onto the
area of the wall where you would like to hang the
unit.
2. Secure the 15 mm (0.6 in) screws into the
corresponding holes of the vertical panel until it is
firmly fixed against the wall.
3. Place the speaker onto the horizontal panel of the
wall-mount unit, making sure to align the 2 screw
holes of the horizontal panel with those of the
speaker.
4. Insert the remaining two 10mm (0.4 in) screws
into the aligned holes and secure the speaker onto
the horizontal panel. The wall-mount unit and
speaker should be securely fixed in place.
appears to show
speaker is being
operated by AC power.
does not appear.
or appears.