One for All URC 8800 - Manual (Page 17)

33 32
LEARNING FUNCTIONS ONTO THE 1L
THROUGH 6L KEYS
The 1L, 2L, 3L, 4L, 5L, and 6L keys can be used to
customize those functions that are unique to your
home entertainment needs. For example, the
a/v Producer does not offer Tracking Up or Down for
a VCR. However, with the learning feature, you can
add these as well as many other functions to the
a/v Producer.
NOTE: Please have your original remote controls handy before
performing learning.
1 (Device Key) Press and release the Device key
(e.g., VCR) where you want a/v
Producer to learn new feature(s).
2 Press and hold SETUP until the
display screen changes from the
device you selected [e.g., VCR and
the TIME] to [TIMED SEQ].
3 x 2 Press MENU – twice, the display
will change to [CONFIGURE].
Press SELECT, the display will
change to [THEATR SEL]. Press
MENU + twice, the display will
x 2 change to [IR LEARNER].
4 x 2 Press SELECT, the display screen
will change to [IR LEARN]. Press
SELECT again.
5 The display screen will change from
[IR LEARN] to [VCR].
a/v Producer is now ready to learn new features.
NOTE: At this point, you can press a different device key (e.g.,TV)
to learn features in a different mode.
6 (Device Key) Press and release the Device key
(e.g., TV) in which you would like to
learn your new function.
NOTE: Steps 7 through 9 need to be completed within
10 seconds. Please read the next three steps before proceeding.
7 Press and release the (1~6) L key
where you want to assign a compo-
nent’s feature. The a/v Producer’s
red light will flash rapidly.
8 Place your original remote control
about 2 inches apart (nose-to-nose)
from the a/v Producer.
NOTE: If the a/v Producer has trouble learning a feature, try mov-
ing your original remote control to the left or right during the
learning process.The position of the IR LED transmitter on your
original remote control may be offset.
9 On your original remote control,
press and hold the key (feature) you
want learned until the red light on
the a/v Producer blinks twice and
the display will read [SUCCESS}. If
the red light on the a/v Producer
does not blink twice or the display
reads [ERROR], stop and repeat
step 7 to 9.
NOTE: You can now repeat steps 6 through 9 to learn additional
functions on the other (1~6) L keys and in different modes.
10 Once the a/v Producer has learned
all desired features, press and
release ESC to exit out of learning
mode.
11 To test a new feature, press and
release a desired device key, fol-
lowed by the (1~ 6) L key where a
corresponding feature was learned.
2"