Onkyo HT-SP904 - Manual (Page 42)

42
Playing Your AV Components
Basic AV Receiver Operation
MASTER VOLUME
VIDEO
STANDBY
TONE DISPLAY STEREO DIMMER MEMORY DIGITAL INPUT TUNING MODE
TUNER TAPE AUX CBL/SAT VCR/DVR DVD MULTI CH C D SETUP ENTER
SETUP MIC
RETURN
CLEAR
LISTENING MODE
AUDIO L R AUX INPUT
STANDBY/ON
PHONES
TUNING PRESET
DISPLAY
MULTI CH
1 4
MUTING
PREVIOUS MENU GUIDE TOP MENU
SP A / B
SETUP RETURN
PLAYLIST/CAT PLAYLIST/CAT
--/---
TAPE/AMP
M D/CDR
DOCK
CABLE
STANDBY/ON
DIMMER ENT D TUN SLEEP
10 11 12
INPUT SELECTOR
REMOTE MODE
V CR/DVR
AUX
CBL/SAT
C D TAPE TUNER
DVD MULTI CH
T V VOL VOL
SAT
VCR
T V
DVD RECEIVER
C D
INPUT
+10 0 CLR
1 2 3
4 5 6
7 8 9
ENTER
CH DISC ALBUM
4
1
1
2
OUTPUT LEVEL
MAX MIN
4
Subwoofer’s
rear panel
1 Use the AV receiver’s input selector buttons to select the input source.
To select the input source with the remote controller, press the
[RECEIVER] REMOTE MODE button, and then use the INPUT SELECTOR
buttons.
2 Start playback on the source component.
To watch a DVD or other video source, on your TV, select the video input that’s con-
nected to the AV receiver’s MONITOR OUT jack.
If your TV is connected to the HDMI OUT, see the tip on page 28.
3 To adjust the volume, use the MASTER VOLUME control, or the remote
controller’s [VOL] button.
The volume can be set to MIN, 1 through 79, or MAX. Since the AV receiver is
designed for home theater enjoyment, it has a wide volume range for precise adjust-
ment.
To set the level of the subwoofer, use the OUTPUT LEVEL control.
Because our ears are less sensitive to very low bass sounds, there’s a temptation to set
the level of the subwoofer too high. As a rule of thumb, set the subwoofer level to what
you think is the optimal level, and then back it off slightly.
4 Select a suitable listening mode and enjoy!
See “Using the Listening Modes” on page 51.
RECEIVER
TUNER TAPE AUX
CBL/SAT VCR/DVR DVD
C D
VCR/DVR CBL/SAT
C D TAPE TUNER
DVD
1 2
6
7 8 9
AUX
4
Remote
controller
AV receiver
VOL
MASTER VOLUME
Remote
controller
AV receiver