Onkyo HT-SP904 - Manual (Page 17)

17
Speakers
For detailed information, see the pages in parentheses.
A STANDBY/ON indicator
Red: Subwoofer in standby mode
Green: Subwoofer on
With the Auto Standby function, the SKW-750
automatically turns on when an input signal is
detected in Standby mode. When there’s no input
signal for a while, the SKW-750 automatically
enters Standby mode.
B OUTPUT LEVEL control (42)
This control is used to adjust the volume of the sub-
woofer.
C LINE INPUT (19)
This RCA input should be connected to the sub-
woofer pre out on the AV receiver with supplied
RCA cable.
Note:
The Auto Standby function turns the subwoofer on when
the input signal exceeds a certain level. If the Auto
Standby function does not work reliably, try slightly
increasing or decreasing the subwoofer output level on
the AV receiver (page 60).
1 Keyhole slots
These keyhole slots can be used to wall-mount the
speaker.
2 Speaker terminals
These push terminals are for connecting the speaker
to your AV Receiver, amp, or other receiver with the
supplied speaker cables. The supplied speaker
cables are color-coded for easy identification. Sim-
ply connect each cable to the same-colored positive
speaker terminal.
3 Speaker mount/bracket inserts
These threaded inserts can be used to attach the
speaker either horizontally or vertically to a speaker
mount or bracket.
Note:
Use commercially available 1/4" screws to attach
the speaker to a speaker mount or bracket.
Subwoofer (SKW-750)
1
2 3
■ Rear
To AC outlet
■ Front
Front, Center & Surround speakers (SKF-750F, SKC-750C, SKM-750S)
1
2
3
■ Rear