Sylvania LD320SSX - Manual (Page 51)

51
EN
INTRODUCTION
PREPARATION
WATCHING TV
OPTIONAL SETTING
OPERATING DVD
DVD
SETTING
TROUBLESHOOTING
INFORMATION
English Español Français
Symptom Remedy
T
V
You switch to a different input
and the volume.
This unit will memorize the volume level from the last time you adjusted it.
If the volume of the sound from another device is higher or lower, then the
loudness will change. •
•
You switch to a different input
and the screen size changes. This unit will memorize the viewing mode from the last time you used the
particular input modes. •
The display image does not
cover the entire screen.
If you are using the unit as a PC monitor, make sure that “Horizontal Position” and
“Vertical Position” in “PC Settings” are set correctly.
If you are watching TV or using the video, S-video, component video or HDMI with
480i input, press [SCREEN MODE ] repeatedly to switch various screen modes. •
•
Captions are displayed as a
white box.
No caption is displayed in the
Closed Caption-supported
program. Interference from buildings or weather conditions may cause captioning to be
incomplete.
Broadcasting station may shorten the program to insert advertisement.
The closed caption decoder cannot read the information of the shortened
program. •
•
No caption is displayed when
playing back a disc or a cassette
tape containing captions.
The disc or cassette tape may be illegally copied, or the caption signal might not
have been read during copying. •
Black box is displayed on the TV
screen.
The text mode is selected for caption. Select “CC1”, “CC2”, “CC3”, “CC4” or “Off”. •
D
V
D
Completely distorted picture or
black/white picture with DVD.
Make sure the disc is compatible with the unit. •
Picture freezes momentarily
during playback. Check the disc for finger prints/scratches and clean with a soft cloth wiping from
center to edge. •
Disc cannot be played.
Clean the disc.
Ensure the disc is correctly inserted.
Check if the disc is defective by trying another disc.
Cancel the parental lock or change the control level.
Insert a correct disc that plays on this unit.
Handle a disc with special care so that it does not have fingerprints, scratches, or
dusts on its surface. •
•
•
•
•
•
Buttons do not work or the unit
stops responding. To completely reset the unit, unplug the AC power cord from the power outlet for
5-10 seconds. •
The unit does not respond to
some operating commands
during playback.
Operations may not be permitted by the disc. Refer to the instructions of the disc. •
Angle does not switch.
The angle cannot be switched for DVD which do not contain multiple angles. In
some cases multiple angles are only recorded for specific scenes. •
Playback does not start when
the title is selected.
Check the “PARENTAL” setting. •
The password for rating level
has been forgotten.
Enter the default password “4737”, then your forgotten password will be cleared. •
Note:
The LCD panel is manufactured to provide many years of useful life. Occasionally a few non active pixels may appear as a fixed point of
blue, green or red. This is not to be considered a defect in the LCD screen.
Some functions are not available in specific modes, but this is not a malfunction. Read the description in this manual for more details on
correct operations.
Some functions are prohibited on some discs. •
•
•