beautypg.com

Remote controller, Installing the batteries, Aiming the remote controller – Onkyo SKF-540F User Manual

Page 13: Ol sensor (13)

background image

13

Remote Controller

Notes:

• If the remote controller doesn’t work reliably, try

replacing the batteries.

• Don’t mix new and old batteries or different types of

batteries.

• If you intend not to use the remote controller for a long

time, remove the batteries to prevent damage from
leakage or corrosion.

• Expired batteries should be removed as soon as possi-

ble to prevent damage from leakage or corrosion.

When using the remote controller, point it toward the AV
receiver’s remote control sensor, as shown below.

Notes:

• The remote controller may not work reliably if the AV

receiver is subjected to bright light, such as direct sun-
light or inverter-type fluorescent lights. Keep this in
mind when installing.

• If another remote controller of the same type is used in

the same room, or the AV receiver is installed close to
equipment that uses infrared rays, the remote control-
ler may not work reliably.

• Don’t put anything on top of the remote controller,

such as a book or magazine, because a button may be
pressed continuously, thereby draining the batteries.

• The remote controller may not work reliably if the AV

receiver is installed in a rack behind colored glass
doors. Keep this in mind when installing.

• The remote controller will not work if there’s an obsta-

cle between it and the AV receiver’s remote control
sensor.

Installing the Batteries

1

To open the battery compartment, press
the small hollow and slide open the cover.

2

Insert the two supplied batteries (AA/R6)
in accordance with the polarity diagram
inside the battery compartment.

3

Slide the cover shut.

Aiming the Remote Controller

Approx. 16 ft.
(5 m)

Remote control sensor

STANDBY indicator

AV receiver

This manual is related to the following products: