Oce North America LIGHTJET 500XL - Manual (Page 18)

LightJet 500XL Maintenance Guide
×
see copyright, disclosure, use and duplication information on pg ii 48058-A 3-2
Other power-up problems include:
§ The LightJet ®
500XL takes longer than 15 minutes to power up. This indicates a servo
laser test failure. The LightJet
®
Explorer Optical Motors Window displays which laser
failed the test in the attenuator fields.
§ If the power circuit breaker switch and the control panel are on, but the blue laser
blower, exhaust cooling fan and cardcage cooling fans are off, contact Océ.
Electronic, Optical and Mechanical Failures
This section provides a list of error conditions for the LightJet
®
500XL. When an error occurs,
the control panel displays:
Errors Encountered
1. Press ENTER to display the error (ESC will clear the error buffer without displaying the
error).
2. After viewing the error, press the SETUP, MEDIA or ON LINE keys to clear the error
buffer. Note that this clears the error buffer, but does not correct the cause of the error.
3. Use the recommended recovery methods described below to troubleshoot the error. If the
printer does not allow you to initiate the recovery process, power down and restart the
printer, then continue the process. Wait at least 15 seconds between powering off and on.
Rapid power cycling can harm the electronics.
If you are unable to resolve the problem, contact Océ (see “Product Support, Documentation and
Service on page ii).
Error 01 – End of Roll During Load
Possible
Cause:
Loaded media is less than 125” in length. Loading the machine requires a
minimum of 125” of media.
Recovery
Method:
Select Set Up/Motor Control/All Motors Reverse. Retract 135 inches of
media.