Appendices, Changing the lamp – Optoma Optoma EP750 User Manual
Page 24
E
nglish
24
Changing the lamp
The projector will detect the lamp life itself. It will show you a
warning message
“Lamp is running out of standard lifetime. Be
sure to replace the lamp as soon as possible.”
When you see this
message, change the lamp as soon as possible.
Make sure the projector has been cooled down for at least 30
minutes before changing the lamp.
Warning :
Lamp compart-
ment is hot! Allow it to cool
down before changing lamp!
4
Lamp Changing Procedure:
1.
Turn off the power to the projector by pressing the Power/Standby button.
2.
Allow the projector to cool down at least 30 minutes.
3.
Turn off the main power switch.
4
. Disconnect the power cord.
5.
Use screwdriver to remove the screw from the cover.
6.
Remove the cover.
7.
Remove the 3 screws from the lamp module.
8.
Pull out the lamp module.
Warning :
To reduce the risk
of personal injury, do not drop the
lamp module or touch the lamp
bulb. The bulb may shatter and
cause injury if it is dropped.
Appendices
To replace the lamp module, reverse the previous steps.
2
3
4
1