Asus T3-P5G43 - Manual (Page 82)

5-20 Chapter 5: BIOS setup
5.4.2 Chipset
The Chipset menu allows you to change the advanced chipset settings. Select an
item then press to display the sub-menu.
Advanced Chipset Setting
WARNING: Setting wrong values in below sections
may cause system to malfunction.
NorthBridge Configuration
Configure North
Bridge
North Bridge chipset Configuration
Memory Remap Feature [Enabled]
Initiate Graphic Adapter [PEG/IGD]
IGD Graphics Mode Select [Enabled, 32MB]
GTT Graphics Memory Size [No VT mode, 2MB]
PAVP Mode [Disabled]
DVMT/FIXED Memory [256MB]
North Bridge Configuration
Memory Remap Feature [Enabled]
Allows you to enable or disable the remapping of overlapped PCI memory
above the total physical memory. Enable this option only when you install 64-
bit operating system. Configuration options: [Enabled] [Disabled]
Initiate Graphic Adapter [PEG/IGD]
Allows you to select the graphics controller as the primary boot device.
Configuration options: [IGD] [PCI/IGD] [PCI/PEG] [PEG/IGD] [PEG/PCI]
IGD Graphics Mode Select [Enabled, 32MB]
Allows you to set the system memory size used by the internal graphics
device. Configuration options: [Enabled, 32MB] [Enabled, 64MB] [Enabled,
126MB]
ENABLE: Allow
remapping of
overlapped PCI memory
above the total
physical memory.
DISABLE: Do not allow
remapping of memory