Oregon Scientific Radio controlled projector alarm clock EW98 - Manual (Page 10)

8
EN
3. Press “SET ALARM” key to save and exit the
setting mode “
” indicates alarm is ON.
Note
1. The alarm will be automatically turned on when
you set the alarm time.
2. During the alarm time setting period, press
and hold “+/CHANNEL” or “-/MIN.MAX.” key
to speed up the change of settings.
USING ALARM FUNCTION
1. Set the alarm time as the above section.
2. In normal time mode, press “ALARM ON/OFF”
key once to display the current alarm time.
3. Press it again to turn alarm ON/OFF.
TO SILENCE THE ALARM
1. Press “SNOOZE/LIGHT” to silence the alarm
for 8 minutes. The “
” will be flashing.
2. Press any other key to turn the alarm off
and activate it again after 24 hours.
Normal time mode Alarm time setting
3. If no key is pressed within 120 seconds, the
alarm will be turned off and be activated
again after 24 hours.
USING THE PROJECTOR
Slide “PROJECTION ON/OFF” switch to turn on/
off the projector, and project to a dark background
within 1-4 meters so that the projected image (time
& temperature) will be shown as below:
Note
1. Slide “PROJECTION ON/OFF” to turn on the
projection function.
2. Press “SNOOZE/LIGHT” to turn on the
projector for 5 seconds.
3. When using DC power adapter, the projector
will be turned on all the time.