Radio Shack PRO-2067 - Manual (Page 39)

39
5. Repeatedly press FUNC then 9 to select the offset frequency you want ( 12.5
kHz , 25.0 kHz , or 50 kHz ).
Note: Offset frequencies above 50 kHz do not appear and are used only for
subaudible decoding mode.
6. Program the trunking frequencies (see “Programming Trunking Frequencies”
on Page 37).
PROGRAMMING FLEET MAPS
If you want to receive a Motorola Type I system, you need to set the fleet map.
Fleet maps are included along with other information about Motorola Type I sys-
tems at www.trunkscanner.com.
Follow these steps to program a fleet map.
1. Press PROG .
2. Press TRUNK .
3. For each bank you want to program, repeatedly press FUNC , ▲ , or ▼ to select
the bank.
4. Press FUNC .
5. Press 8 . You see:
6. Enter the size code information supplied with the Type I system information,
referring to the instruction that appears on the display. If the information was
not supplied, try the following common fleet maps.
B
L
O
C
K Size Code
1 2 3 4 5 6 7 8
0 S11 S4 S4 S12 S4 S3 S10 S1
1 S11 S4 S4 — S4 S10 S10 S1
2 S11 S4 S4 S4 S12 S4 S11 S2
20-196a.fm Page 39 Friday, June 2, 2000 3:48 PM