Radio Shack ET-910 - Manual (Page 8)

8
MOUNTING THE BASE
ON A WALL
Using the supplied mounting bracket,
you can mount the ET-910’s base on
a phone jack wall plate or directly on
the wall.
To prepare the bracket for mounting,
twist off the tabs attached to the cen-
ter of the bracket and press them se-
curely into the holes on the narrow
end of the bracket.
Mounting on a Wall Plate
1. Press the ET-910’s AC cord
under the recessed clip directly
below it on the bottom of the
phone.
2. Plug one end of the supplied 7-
inch modular cord into the TO
TEL LINE jack, then press the
cord under the other recessed
clip on the bottom of the phone.
3. Insert the tabs on the supplied
mounting bracket into the slots
on the base’s bottom. Then
press the bracket down until it
snaps into place.
TO TEL. LINE
43-1085.fm Page 8 Tuesday, August 17, 1999 2:31 PM