Radio Shack ET-910 - Manual (Page 10)

10
Mounting Directly on the
Wall
Using a drill (not supplied) and the
supplied screws and spacers, you
can easily mount your ET-910 direct-
ly on the wall.
1. At the desired mounting loca-
tion, drill two holes 3 15 /
16
inches
apart, one above the other.
2. Place a spacer over each screw,
then thread a screw into each
wall hole until the screw’s head
extends about
1 /
4
inch from the
wall.
3. Press the ET-910’s AC cord
under the recessed clip directly
below it on the bottom of the
phone.
4. Plug one end of the supplied 7-
foot modular cord into the TO
TEL LINE jack, then press the
cord under the other recessed
clip on the bottom of the phone.
5. Insert the tabs on the supplied
mounting bracket into the slots
on the base’s bottom, then press
the bracket down until it snaps
into place.
3 15 /
16
”
TO TEL. LINE
43-1085.fm Page 10 Tuesday, August 17, 1999 2:31 PM