beautypg.com

Setting the dialing mode – Radio Shack ET-1112 User Manual

Page 8

background image

8

• Using a pencil eraser, clean the

charging contacts on the handset
and the base about once a month.

• If the TALK/BATT indicator does not

light and the phone does not work,
recharge the battery pack. (The bat-
tery power might be too low to light
the indicator.)

• If the battery pack becomes weak

during a call, you hear a beep and
the TALK/BATT indicator flashes
every 4 seconds. Recharge the bat-
tery pack.

• If the battery pack is completely dis-

charged, the handset loses the
security access-protection code. To
reset the code, place the handset on
the base and charge the battery
pack.

• The supplied battery pack should

last for about a year. When the bat-
tery pack loses its ability to fully
recharge, order a replacement bat-
tery pack from your local
RadioShack store (see “Replacing
the Battery Pack” on Page 18).

SETTING THE DIALING
MODE

Set

PULSE-TONE

on the back of the

base for the type of service you have. If
you are not sure which type you have,
once the battery pack is fully charged,
do this test.

1. Be sure

PULSE-TONE

is set to

TONE

.

2. Lift the handset, press

TALK

, and lis-

ten for a dial tone.

3. Press any number other than

0

.

Note: If your phone system requires
that you dial an access code (9, for
example) before you dial an outside
number, do not press the access
code either.

If the dial tone stops, you have
touch-tone service. Leave

PULSE-

TONE

set to

TONE

.

If the dial tone continues, you have
pulse service. Set

PULSE-TONE

to

PULSE

.

43-1112.fm Page 8 Monday, September 13, 1999 5:08 PM