Radio Shack ET-1112 - Manual (Page 11)

11
Press MUTE again to resume your
phone conversation.
USING FLASH
FLASH performs the electronic equiva-
lent of a switchhook operation for spe-
cial services, such as Call Waiting.
For example, if you have Call Waiting,
press
FLASH to answer an incoming call
without disconnecting the current call.
Press
FLASH again to return to the first
call.
Note: If you do not have any special
phone services, pressing
FLASH might
disconnect the current call.
USING TONE SERVICES
ON A PULSE LINE
Some special services, such as bank-
by-phone, require tone signals. If you
have pulse service, you can still use
these special tone services by following
these steps.
1. Be sure PULSE-TONE is set to
PULSE .
2. Dial the service’s main number.
3. When the service answers, press
TONE ( ). Any additional numbers
you dial are sent as tone signals.
4. After you complete the call, return
the handset to the base or press
TALK . The phone automatically
resets to the pulse mode.
PAGING
To page the person who has the hand-
set or to locate the handset when the
phone is not in use, press
PAGE on the
base. The handset beeps for about 15
seconds. To stop the beeping sooner,
press
TALK on the handset twice or
PAGE on the base.
Notes:
• Make sure you press TALK twice to
stop the handset from beeping. If
you press
TALK only once, you get a
dial tone.
• If you receive a call while the page is
sounding, the handset stops beep-
ing and starts ringing.
PAGE
43-1112.fm Page 11 Monday, September 13, 1999 5:08 PM