RCA VS2000 User Manual
Page 11
4. INSTALLATION
“
Installation
”
menu helps you to setup a variety of
parameters necessary for receiving signal, add
new service, upgrade the new software and reset
the channel data.
Select
“
Installation
”
menu in main menu, and you
will be asked to enter your PIN code.
You can find the following
“
Installation
”
screen by
entering it.
MENU OPERATION
19
MENU OPERATION
18
LNB Power
LNB Type
LNB Freq.
22KHz
Search option
DiSEqC 1.0
Motor
: Depending on the user
’
s antenna LNB, you can supply either LNB power by
setting
“
ON
”
or not by setting
“
OFF
”
. Normally set this to
“
ON
”
.
: You can select the LNB type.
: You can select the predefined LNB frequency or manually enter a specific
frequency in MHz unit by pressing numeric keys.
: In case you are using two antennas connected to a 22KHz tone switch box,
you can supply either 22KHz by setting
“
ON
”
or off by setting
“
OFF
”
to select
antenna.
: You can search all the free channels & scramble channels or only free channels
or onlyscramble channels by setting the search option.
: If you have DiSEqC box, you can choose port by selecting port number.
Otherwise, choose
“
none
”
.
: If you have a DiSEqC 1.2 motorised system, then you can takeadvantage of the
DiSEqC 1.2 functions available. Choose Installer as Motor and press “F1” key.
After that, adjust antenna direction using browse keys.
4.A. ANTENNA SETUP
Your receiver includes the preprogrammed information of transponders contained in various
satellites.
You can update the transponder list preprogrammed
for a satellite by adding a new transponder to it or
modifying the information of the existing transponder.
(Refer to the Channel Scan described in section 4.B)
Select
“
Antenna Setup
”
menu in
“
Installation
”
menu
and the following screen will be displayed.
Select the desired satellite using the
“
left/right
”
keys(
◀∙▶
).Set
“
LNB Power
”
,
“
LNB Type
”
,
“
LNB
Freq
”
,
“
22KHz
”
,
“
Search Option
”
, and
“
DiSEqC 1.0
”
fields to the appropriate value using the left/right
keys(
◀∙▶
) at each field.
4. A. 1 Automatic Scan
Check the signal strength. Press
“
OK
”
key to start the scan procedure.You can see the
progressive status of channel searching.
Please note that the scan procedure may take a few minutes.
Press the
“
menu
”
key or
“
exit
”
key to return to previous menu.
4. A. 2 Blind Scan
Blind Scan search the channel when you don’t know
the transponder information.
Press the F2 key to start the blind scan procedure
and the following screen will be displayed.
Please note that the scan procedure may take a few
minutes.
Press the “menu” key or “exit” key to return to
previous menu.