Roberts Gorden UHA SERIES 200 - Manual (Page 32)

COMBAT ® UHA U NIT H EATER I NSTALLATION O PERATION AND S ERVICE M ANUAL
26
Burner Observation
Window Make sure it is clean and free of cracks or holes.
Clean and replace as required.
Combustion Fan Scroll,
Wheel and Motor Compressed air or a vacuum cleaner may be used to clean dust and dirt.
Inshot Burners and
Orifices Clear of obstructions (even spider webs will cause problems).
Carefully remove any dust and debris from the burner.
Direct-Spark Igniter Replace if there are cracked ceramics, excessive carbon residue, or erosion
of the electrode.
The electrode gap should be 1/8" (3.2 mm).
Thermostat There should be no exposed wire or damage to the device or wiring.
See Page 19, Section 10.
Suspension Points Make sure the heater is hanging securely.
Look for signs of wear on the suspension materials or ceiling.
See Page 6, Figure 2.
Silicone Tubing Ensure tight, secure fit on all pressure fittings at pressure switch,
burner partition, and blower outlet.
Gas Valve Verify that cap covering pressure regulator adjustment screw is secure and
has not been tampered with.
Verify all wiring connections.
Condensate Drain
(when installed) Flush drain and clear any obstructions.