RoyalTek RGM-2000 - Manual (Page 6)

Step 3:Place your Sapphire on the outside roof of your vehicle with magnetic base.
Step 4:Power on your Notebook PC or Handheld PC. If you have ordered a cigarette
adaptor, please plug the cigarette adaptor into the cigarette outlet of the car.
Step 5:Choose the correct COM port for running the map or navigation software.
Step 6:Run the Sapphire test program. Please refer to “How to test your Sapphire”.
Notice:
(1) Make sure the power is off before started.
(2) For safety reason, please do not install Sapphire while driving.
(3) To receive NMEA0183 navigational data, please use the Hyper Terminal
program of Windows95/98

/ME

/2000

. Please setup the COM port connected
with Sapphire to:
Baud rate : 4800
Data bit : 8
Parity : None
Stop bit : 1
Flow control : None.
(4) The formats of NMEA messages are illustrated on Software Data section.
(5) To prevent from the poor contact, the 4-pin mini din connector was designed as
good fitting. It is strongly recommend that user doesn’t plug and unplug this
connector frequently.