Operation, Accessories – Ryobi RT401W User Manual
Page 19
OPERATION
19
Outside routing
See Figure 24
1. Place your workpiece on the tabletop relative to the
router bit.
2. Feed your workpiece through the bit in the direction of
the arrow. Always feed against the router bit’s direction
of rotation.
Fig. 23
Fig. 24
ACCESSORIES
Fig. 25
Using miter guide
See Figure 25
The miter guide can serve as extra support for routing
small workpieces and for ends of long workpieces.
NOTE: Make sure that the fence and miter bar slot are
parallel before cutting.
To cut miters, unclamp knob that secures the protractor
head. Turn head up to 60° in either direction. Retighten
knob.
When making cuts using the miter guide, hold the work-
piece firmly against the fence, the miter guide, and the
table.
WARNING:
Do not allow any body part to be in line with the router
bit at any time when the miter gauge is in use. Doing
so could lead to serious personal injury.
Bdal 6144.461 3Sprachen 04.06.2005 11:56 Uhr Seite 19