Radio Shack CD-8150 - Manual (Page 16)

16
PLAYING A SEQUENCE
OF TRACKS
You can program up to 32 selections
to play in any order you choose. A “se-
lection” can be an individual track or
an entire CD.
Follow these steps to program and
play a sequence of tracks.
Hint: You can open the disc tray com-
partment while you program the se-
quence, so you can check the loaded
CDs’ tracks.
1. Press STOP to cancel the cur-
rent function.
2. Press DISC NO. (or DISC SKIP ) to
select a CD.
To enter all the tracks on a CD as
one selection, skip to Step 4.
3. Press TRACK NO. (or or )
to select a track.
4. Press MEMORY to store the selec-
tion into memory. The MEMORY
indicator appears and the time
display shows
P-01 (pro-
grammed selection 1).
Note: If you enter a track number
higher than the highest track on a
CD, this entry is ignored during
programmed play.
5. Repeat Steps 2–4 for each track
or CD you want to program, up to
32 selections. The programmed
selection number on the display
increases with each added selec-
tion (
P-02 to P-32 ).
Note: If you try to store more than
32 selections, the CD changer
briefly displays
FULL .
6. Press PLAY to play the se-
quence. If you programmed indi-
vidual tracks, the music calendar
displays the number of pro-
grammed tracks, with the current
track number flashing. If you pro-
grammed an entire CD, the music
calendar displays only the current
track playing.
After the CD changer plays all
programmed tracks, it stops and
P-01 reappears on the time dis-
play. The sequence is still in mem-
ory, so you can press
PLAY to
replay the sequence.
Notes:
• You can use or , SEARCH
or , INTRO SCAN , and
SHUFFLE during programmed
play.
• You cannot use the DISC SKIP ,
DISC NO. , or TRACK NO. buttons
during programmed play.
illustration
42-5071.fm Page 16 Thursday, August 12, 1999 10:45 AM