RCA F38310 - Manual (Page 34)

BASIC TV OPERATION
3 0
Using the INPUT Button
1. Repeatedly press the INPUT button to scroll through the available
input sources until you find the input associated with the
component (such as VCR or DVD player) you want to view.
1 2 3
4 5 6
7 8 9
0
ON•OFF TV VCR1
DVD
MUTE SKIP
GO BACK FETCH
GUIDE INFO
MENU CLEAR
INPUT
REVERSE PLAY FORWARD
RECORD
PIP SWAP CH CTRL WHO
STOP PAUSE
ANTENNA
AUX DIRECTV
OK
CH +
CH
VOL
VOL
VCR2
INPUT
button
Watch the channel banner to see the input sources change
with each press of the INPUT button.
Input
source
2. Once you have found the input source you want, stop pressing
INPUT.
• If you tune to VID1 and your VCR is connected to that input,
you will be able to view your VCR. To play, stop, or rewind the
VCR1 tape using the remote that came with your TV, you must
first press the VCR1 button to put the remote control in VCR
mode.
There are other ways of selecting an input channel:
• Program the component (VCR, DVD, etc.) buttons on the remote
control to automatically tune to the correct input channel when
pressed. See the section in this book, “System Options and
Preferences“ for information on auto tuning.
• After pressing INPUT on the remote, enter the digits 1, 2, 3, 4, or 5
to tune to (S)VID1, 2, 3, FRONT, or CMPNT respectively.
• After pressing INPUT on the remote, press GUIDE on the remote
control to view a guide-like list of your line inputs and
corresponding channels.