Runco DTV-940 - Manual (Page 12)

2-2
RUNCO key : Turns on backlight
ADJ. : Adjust key, to enter or exit the adjustment mode.
Address key (recessed key) : to enter the address of the projec-
tor (between 0 and 9). Press the address key, followed by press-
ing one digit button between 0 and 9. When addressed to O , the
remote will talk to any projector, regardless of its address.
STBY : Stand by button:
- To initiate remote power up operation
- To stop projection without main power off.
Pause : To mute the image, press PAUSE. The image disappears
but full power is retained for immediate restarting.
Mute : Not used
Help : Not used.
Digit buttons : Direct aspect ratio selection.
Sound controls : Not used.
Picture controls : Use these buttons to obtain the desired level
(see also ‘Controlling’) for each picture function.
Phase : Not used.
Text : When adjusting one of the image controls during a meet-
ing, the displayed bar scale can be removed by pressing ‘TEXT’
key first. To re-display the bar scale on the screen, press ‘TEXT’
key again. ‘TEXT’key is only active in operational mode. When
‘TEXT’is off, no warning message will be displayed.
FREEZ : Not used.
ENTER : To start up the adjustment mode or to confirm an
adjustment or selection in the adjustment mode.
EXIT : To leave the adjustment mode or to scroll upwards when
in the adjustment mode.
Control disc : To make menu selections when in the adjustment
mode. Also allows to increment or decrement an adjustment in
the adjustment mode.
Control disc up = up arrow in the menus
Control disc down = down arrow in the menus
Control disc to the right = arrow to the right on the menus
Control disc to the left = arrow to the left on the menus
1
2
3
4
5
6
7
8
9
10
11
13
14
15
16
12