Renesas R8C/1B User Manual
Page 5
26. Select the Debug build configuration in the left hand drop
down list on the toolbar.
27. Click on the “Build” icon to compile, assemble and link the project.
4. Programming and Debug
28. Ensure the “SessionR8C_E8a_SYSTEM” session in the
right hand drop down list on the toolbar is selected.
29. Click the
30. The “Emulator mode” dialog will be shown. Select the
correct MCU group and device type (e.g. R8C/1B
Group and R5F211B4 for E8A_RSKR8C1B).
Please note that the “Emulator mode” dialog
shown here will only appear the FIRST time you
connect to the target within a project. On
subsequent connections the “Emulator setting”
dialog will appear, please choose the same
options to connect.
31. Select “Erase Flash and Connect”.
32. If the E8a is to provide power to the CPU board,
select “Power Target from Emulator” and choose the
“5.0V” option.
Otherwise connect a 5V centre positive supply.
33. Click
34. Ensure the “Enable advanced setting” checkbox is clea
Click
red. Set the firmware location to “User Flash Area”.
35.
6. Accept any dialog warning that an older version of E8a firmware is necessary to work with the application. Allow
The connection to the Renesas Starter Kit will be completed and will activate the debugger buttons on the
3
download of firmware to complete, this may take several seconds.
High-performance Embedded Workshop toolbar.