RCA look 15377550 - Manual (Page 8)

Setup and Connections
6
Back of the Receiver
The diagram below describes each of the back panel jacks found on
your digital receiver. When connecting A/V cables, be sure to connect
corresponding OUTPUTS and INPUTS (Video to Video, Right Audio to
Right Audio, etc.).
IN
FROM
AUX
OUT
TO
TV
S-VIDEO
OUT
VIDEO R L AUDIO
REMOTE
OUT
MMDS INPUT
PHONE JACK
CH 4
CH 3
OUT OUT
SMART CARD
IN FROM ANT Use to
connect the digital
receiver system to an
alternative off-air
antenna or cable TV
signal.
AUDIO/VIDEO Provide better sound
and picture quality than the OUT TO
TV jack. If your TV has audio/video
capability, use these jacks to connect
the digital receiver to your TV. You
must also connect the VIDEO jack.
OUT TO TV Use to connect the digital
receiver to your TV. However, if your TV
has audio/video jacks, you should use
those jacks to get better picture and
sound quality.
SMART CARD Identifies you
to your program providers. The
digital receiver system requires
a valid smart card.
S-VIDEO Provides the best
picture quality. If your TV has
S-VIDEO capability, use this jack
along with the audio/video jacks
to connect the digital receiver to
your TV.