Radio Shack 15-1925 - Manual (Page 9)

Need help? Call 1-800-950-7044
9
SETTING UP YOUR REMOTE
CONTROL
1. Refer to “Manufacturers’ Codes” on Page 26
and write down the codes for your original
remote controls.
Note: Some manufacturers have several
possible codes listed. Try each until you find
the correct code. See “If You Have Prob-
lems” on Page 20 if you need help.
2. Press the device key for the type of remote
you are replacing ( CD , VCR , CBL , TV , AUX1
or AUX2 ).
Hold down SET UP until the red light blinks
twice, then release it. Enter the 3-digit code.
For example, to replace a TV’s remote con-
trol (manufacturer’s setup code 154), press:
TV – SET UP – 1– 5 – 4
3. When the red light blinks twice again, the 6
in 1 has accepted the code.
4. Point the 6 in 1 IR/RF Remote Control at
your device and press PWR (or CH s for
some cable boxes). Your device should turn
off (or on, if it was off).
If the remote does not operate your device,
try the other codes listed in the “Manufac-
turer’s Codes” section for your brand of TV,
VCR, cable converter, or other device.
Repeat Steps 2–5 for additional devices.
15-1925.fm Page 9 Monday, July 19, 1999 12:59 PM