Radio Shack 15-1925 - Manual (Page 18)

Need help? Call 1-800-950-7044
18
Follow these steps to control Plug ’n Power mod-
ules.
1. Position the IR command console within the
RF command console’s line of sight.
Note: For the best operation, position the
controllers at least 2 feet apart.
2. Plug the IR command console’s power cord
into any standard AC outlet.
3. Set the house code dial on top of the IR com-
mand console to the same letter as your
Plug ’n Power modules.
4. Set the selector switch on the IR command
console for the group of modules you want to
control (1–4 or 5–8).
5. Press Plug ’n Power on the 6 in 1 IR/RF
Remote Control.
6. To turn on all light and appliance modules set
to the same code as the IR command con-
sole, press
All Lts On (PWR) on the 6 in 1 IR/
RF Remote Control, or ALL LIGHTS ON on
the IR command console.
To turn off all light and appliance modules set
to the same house code as the IR command
console, press
All Off ( MUTE ) on the 6 in 1
IR/RF Remote Control, or ALL UNITS OFF
on the IR command console.
7. To turn on or off specific lights and appli-
ances using the 6 in 1 IR/RF Remote Con-
trol, press the digit key (
1 , 2 , 3 , 4 , 5 , 6 , 7 , or 8 )
for the module you want to control. Then
press
ON or OFF ( CH s or CH t ).
To control specific lights and appliances
directly from the IR command console, press
the button on the console that corresponds
to the number of the module you want to
control (1/5, 2/6, 3/7, 4/8). Then use the
function keys on the IR command console to
control the device.
15-1925.fm Page 18 Monday, July 19, 1999 12:59 PM