RoyalTek RBT-1000 - Manual (Page 11)

6
2.4. Getting Started
2.4.1. STEP 1: Charge the Battery
1. Before you use the Bluetooth GPS Receiver, the battery must be
charged. Connect the power charger to the power jack, and then plug
into an electrical outlet. As the device is charging, the Battery Status
LED will show a yellow light.
2. When the battery is fully charged, the Battery Status LED will turn
off. Unplug the device and remove the charger.
2.4.2. STEP 2: Turn on Receiver and Wait for GPS Fix
1. The GPS Status LED will initially show a steady green light to show
that the position has not been fixed yet.
2. After the position is fixed, the GPS Status LED will be showing
flashing green. Now you are ready to connect to your
Bluetooth-enabled mobile device and use your GPS application.
2.4.3. STEP 3: Connect to Bluetooth-Enabled Devices
1. From your Bluetooth-enabled mobile device, perform a Bluetooth
device discovery. Refer to the user documentation for your
Bluetooth-enabled device for instructions.
2. After connection is created between Bluetooth-enabled device and
Bluetooth GPS, the LED will show flashing blue light.
Note: If it is needed to type in Pin code during configuration, please Key in
“ 0000”.
2.4.4. STEP 4: Use GPS Application
1. Load your GPS mapping or routing software, along with the
corresponding maps of the areas that you are occupying or plan to
travel to.
2. Start the application. Make sure the application is set for the COM
port that your Bluetooth-enabled mobile device will use for serial
communication. Now you should be ready to use your GPS
application as directed by the user documentation that came with the
software. More configurations may be necessary.
3. Refer to the following software application user manual to set up the
parameters of the device via Bluetooth radio.