Ryobi BT3000 - Manual (Page 38)

Page 38
ACCESSORIES
Following is a list of optional accessories for the BT3000 table saw.
PART NO. DESCRIPTION PART NO. DESCRIPTION
4010300 Metal Work Stand 4050300 User Kit (Nuts and Bolts)
4010330 Work Stand Casters IDV28 28 Gal. Vacuum
4650300 36T 10 in. (254 mm) Standard Blade (Carbide Tipped) 4070333 Zero Clearance Throat
4650324 24T 10 in. (254 mm) Rip Blade (Carbide Tipped) Plate (Set of 2)
4650340 40T 10 in. (254 mm) Crosscut Blade (Carbide Tipped) 4080300 Accessory Table
4650360 60T 10 in. (254 mm) Finish Crosscut Blade (Carbide Tipped) 4080330 Accessory Table Clamp
4070300 Dust Bag 4658718 6-1/2 in. (165 mm) Adjustable Dado
4070330 Dado Throat Plate 4730305 Wide Table Leg Set
4060300 Long Miter Fence 4730310 Quick Fold Table
4060330 Stop Block Kit 4730320 Air Flotation/Vacuum Clamp
4710300 Miter Clamp Kit Table
4730300 Wide Table Kit 4060305 Rapid Set Micro-Adjust Device
4950300 Router and Jig Saw Mounting Kit 6360395 Push Block
These accessories may be ordered through your local RYOBI dealer or Ryobi Authorized Service Center. They have been
specially designed for the BT3000 table saw. Always use recommended RYOBI accessories for highest quality, convenience
and safety. Call Ryobi Customer Service No. 1-800-525-2579 in the United States or 1-800-265-6778 in Canada for your
nearest Ryobi Factory Service Center.
WARNING:
This saw's motor cord must only be plugged into the receptacle provided on the saw which is controlled by the saw's
master switch. Never plug the motor cord directly into an extension cord as this will prevent the ability to switch the
saw OFF.
**Ampere rating
(on tool faceplate) 0-2.0 2.1-3.4 3.5-5.0 5.1-7.0 7.1-12.0 12.1-16.0
Cord Length Wire Size (A.W.G.)
25' 16 16 16 16 14 14
50' 16 16 16 14 14 12
Keep the extension cord clear of the working area. Position the cord
so that it will not get caught on lumber, tools or other obstructions
while you are working with a power tool.
**Used on 12 gage - 20 amp circuit.
CAUTION
:
WARNING:
To avoid the risk of personal injury or damage to your saw or work, DO NOT use accessories not recommended by
RYOBI.
EXTENSION CORD CAUTION
When using a power tool at a considerable distance from a power
source, be sure to use an extension cord that has the capacity
to handle the current the tool will draw. An undersized cord will
cause a drop in line voltage, resulting in overheating and loss of
power. Use the chart to determine the minimum wire size
required in an extension cord. Only round jacketed cords recog-
nized by Underwriter's Laboratories (UL) should be used.
When working with a tool outdoors, use an extension cord that
is designed for outside use. This is indicated by the letters "WA"
on the cord's jacket.
Before using any extension cord, inspect it for loose or exposed
wires and cut or worn insulation.