Radio Shack ET-550 - Manual (Page 17)

17
USING TONE SERVICES
ON A PULSE LINE
Some special services, such as bank-
by-phone, require tone signals. If you
have pulse service, you can still use
these special tone services by follow-
ing these steps.
1. Be sure P
• •
T is set to P .
2. Dial the service’s main number
using the keypad at the base or
the handset.
3. When the service answers, press
TONE/ . Any additional numbers
you dial are sent as tone signals.
4. After you complete the call, return
the handset to the base, press
TALK , or press SPEAKER . The
phone automatically resets to the
pulse mode.
MEMORY DIALING
You can store up to 20 numbers in the
ET-550’s memory (10 in the handset’s
memory and another 10 in the base’s
memory), then dial a stored number by
pressing
MEMO then a one-digit mem-
ory location number.
Notes:
• Each number you store can be up
to 16 digits long.
• You cannot dial the number stored
in one memory (the base or the
handset) using the keypad on the
other.
Storing a Number in Memory
Notes:
• If you wait more than 20 seconds
between each key press, an error
tone sounds and the phone exits
the programming mode.
• To store a number in the base’s
memory, begin with Step 2.
1. To store a number in handset’s
memory, lift the handset. If you
hear a tone, press
TALK to turn it
off.
43-1050a.fm Page 17 Tuesday, August 17, 1999 12:56 PM