Dismounting the loader, Dismounting the loader -7, Assembly – Rhinotek 1645 User Manual

Page 41: Assembl y

ASSEMBLY

1640-1645 01/11

Assembly Section 3-7

ASSEMBL

5. On level ground, tilt the attachment down 90 degrees

and lower it to the ground. Lower the loader further to
slightly raise the front of the tractor of the tractor off
the ground. Drive the tractor in reverse while the
attachment is on the ground for 20-30 feet to insure
the attachment does not disconnect. If the attach-
ment disconnects during this process, discontinue
the use of attachment and contact your dealer.

Do not use an attachment that is not securely attachment that is not
securely attached to the quick hitch. The attachment could fall resulting in
severe crushing injuries or death to the operator or bystanders.

Dismounting the Loader

1. Locate tractor and loader on firm level ground.
2. With bucket raised above ground, tilt bucket

down approximately 30 degrees from level.

3. Lower boom by retracting lift cylinders to lift

tractor front end (tires can be off ground).

4. Stop Engine. Allow tractor front end to lower by

relaxing ONLY lift cylinders with control lever.
This will remove pressure on hitch pins (See
Figure Asm-L-0002).

NOTE: Do not relax bucket Cylinders.

This manual is related to the following products:

1640