Radio Shack Light and Learn Remote - Manual (Page 17)

17 Operation
Note: For on-air broadcast scans, press TV , then
press SCAN/FAV to start the scan.
USING FAVORITE CHANNEL SCAN
To scan favorite channels, you must first program the
favorite channel table (see “Programming Favorite
Channel Scan” on Page 10).
Press the desired device key ( TV or CBL/SAT ), then
press SCAN/FAV . The remote tunes to each favorite
channel in ascending order every three seconds.
Press any key to stop the scan.
USING MACROS
Press the desired macro key once for the first channel
you programmed (see “Programming Macros” on
Page 12), twice for the second channel, and so on.
USING THE POWER KEY
To turn on all devices, hold down POWER for at least 2
seconds. Each device turns on in the sequence you
programmed (see “Programming the Power Key” on
Page 12).
To turn off all devices, press TV , then hold down POW-
ER for at least 2 seconds. You should see each device
turn off in sequence.
Note: If you do not press TV first before holding down
POWER , the sequence will skip the currently selected
device.
CHANGING VOLUME LOCK
Your remote’s Volume Lock is preset so the volume
and mute keys only control the TV volume, no matter
what device is selected. If you want the remote to con-
trol the TV’s volume only, skip this section and leave
the original settings intact.
However, if you want to control another device’s vol-
ume functions (for example, CBL/SAT, VCR, DVD,