Radio Shack Light and Learn Remote - Manual (Page 16)

16 Operation
USING THE REMOTE
Once you have completed all the programming for the
remote (see “Preparation” on Page 7), you are ready
to use your 6-In-One Remote.
1. Point the remote at the desired device and press
the device key ( TV , VCR , CBL/SAT , DVD , CD , or
AUX ). Then press POWER to turn on the device.
2. Press the desired command keys.
3. Repeat Steps 1 and 2 for all other devices you
want to operate.
4. To turn off the last device you selected, press
POWER .
To turn off another device, press the device key,
then press
POWER . Repeat to turn off all devices.
Note: You can program POWER as a master power
key to turn all devices on and off in a sequence. See
“Programming the Power Key” on Page 12.
USING THE LIGHT
Your remote has a backlight so you can see the keys
in the dark. To turn on the light, press
at the top
right of the remote.
When you press a key, the remote lights for a few sec-
onds. To turn off the light, press
again.
USING CHANNEL SCAN
Note: If you programmed SCAN/FAV for Favorite Chan-
nel Scan, you cannot use it for Channel Scan until you
reset
SCAN/FAV (see “Resetting Scan” on Page 11).
If you want to view a sample of every channel on your
cable or SAT/DSS service, press
CBL/SAT , then press
SCAN/FAV . Starting with the current channel, the re-
mote control tunes to each channel in ascending order
every three seconds. Press any key to stop the scan.