Ricoh PROJECTOR PJ S2130 - Manual (Page 3)

2
English
Usage Notice
Precautions
Follow all warnings, precautions and maintenance as recom-
mended in this user’s guide to maximize the life of your unit.
■ Warning- This apparatus must be earthed.
■ Warning- Do not look into the projector’s lens when the
lamp is on. The bright light may hurt your eyes.
■ Warning- To reduce the risk of fire or electric shock, do not
expose this projector to rain or moisture.
■ Warning- Please do not open or disassemble the projector
as this may cause electric shock.
■ Warning- When replacing the lamp, please allow unit to
cool down, and follow all replacement instruc-
tions..
■ Warning- This projector will detect the life of the lamp
itself. Please be sure to change the lamp when it
shows warning messages.
■ Warning- When switching the projector off, please ensure
the cooling cycle has been completed before
disconnecting power. Allow 60 seconds for the
projector to cool down.
■ Warning- Do not use lens cap when projector is powered
on.
■ Warning- Turn on the projector first and then the signal
sources.
■ Warning- When the lamp reaches the end of its life, it will
burn out and may make a loud popping sound.
If this happens, the projector will not turn back
on until the lamp module has been replaced. To
replace the lamp, follow the procedures listed
under “Replacing the Lamp”.
■ Warning- Do not remove the cabinet cover, or you may be
exposed to dangerous voltage. Refer servicing to
qualified service personnel only.