RIDGID R82233 - Manual (Page 12)

12
OPERATION
TO INSTALL BATTERY PACK
See Figure 4.

Place the battery pack in the impact driver, aligning raised
rib on battery pack with groove in the driver’s battery
port.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured to the
impact driver before beginning operation.
TO REMOVE BATTERY PACK
See Figure 5.

Locate the latches on the side of the battery pack and
depress both sides to release the battery pack from the
impact driver.
 Remove the battery pack.
WARNING:
Battery tools are always in operating condition.
Therefore, switch should always be locked when
not in use or carrying at your side.
PADDLE SWITCH
See Figure 6.
To turn the impact driver
ON, depress the paddle switch. To
turn it OFF, release the paddle switch.
VARIABLE SPEED
See Figure 6.
This tool has a variable speed switch that delivers higher
speed and torque with increased switch pressure. Speed is
controlled by the amount of paddle switch depression.
NOTE: You might hear a whistling or ringing noise from
the switch during use. Do not be concerned; this is a
normal part of the switch function.
Fig. 4
Fig. 5
DEPRESS LATCHES TO
RELEASE BATTERY PACK
RAISED RIBS
LATCHES