Ryobi 4950301 - Manual (Page 11)

Page 11
ROUTER MOUNTING
TO MOUNT ROUTER WITH PLATE TO
ACCESSORY TABLE:
■ Place the router with the mounting plate under the
accessory table.
See Figure 11.
■ Secure the mounting plate to accessory table using
the four #1/4-20 x 1/2 in. flat head screws provided.
NOTE: The accessory table can be removed from
the table saw to attach the router and mounting plate.
Follow instructions in the table saw operator's manual
for removing and reattaching the accessory table.
■ Tighten screws securely.
TO INSTALL ROUTER BIT AND THROAT PLATE:
■ Follow the instructions in the operator's manual of
your router for this procedure. Install router bit and
securely tighten in collet.
CAUTION:
Make sure the router bit will not strike the accessory
table or any metal surface.
■ Select the correct size throat plate for the size of the
router bit. Align the tab on the throat plate with the slot
in the accessory table and snap in place. Make sure
the throat plate is firmly seated below the table
surface. Recheck the router bit to make sure it will not
strike the throat plate.
WARNING:
The router throat plates are included to assure no
more than 1/4 in. (6.4 mm) clearance between the
cutter and the opening in the throat plate. Use correct
throat plate. Do not use a router bit smaller than 1/8
in. (3.2 mm) or larger than 2 in. (50 mm) in diameter.
TO INSTALL TABLE CLAMPING BRACKET:
The lever on the accessory table will tighten the table
securely to the front rail. The weight of the router and
mounting plate may cause the accessory table to loosen
or have movement at the rear of the table. To avoid this,
install the table clamping bracket supplied with this kit.
■ Remove end plug from rear rail as shown in
Figure 12.
■ Slide one of the T-nuts into the front channel of the
rear rail and under the accessory table.
■ The table clamping bracket fits in the bottom slot of
the rear rail. The slotted top of this bracket wraps
Fig.11
TABLE CLAMPING BRACKET
SHOWN COMPLETELY ASSEMBLED
ACCESSORY TABLE
TABLE
CLAMPING BRACKET
T-NUT
REAR RAIL
5/16 in. WASHER
KNOB BOLT
END PLUG
Fig.12
SLOT
THROAT PLATE
#1/4-20 SCREWS (PROVIDED)
ROUTER
WITH MOUNTING
PLATE ATTACHED
ACCESSORY TABLE