RoyalTek MBT-1100 - Manual (Page 5)

25 Status LEDs showing GPS, Bluetooth, Power, Memory status
26 Original Display
1 Yellow LED indicates power is in charging
2 Blinking Amber LED indicates Battery Low
3 Glowing Green LED indicates position is fixed
Blinking Green LED indicates position not fixed
4 Glowing RED LED indicates Memory Full (GPS Green
LED off)
Erased memory data, RED LED Blinking
5 Glowing Blue LED indicates Bluetooth is connected
Blinking Blue LED indicates Bluetooth is not fixed
Location Log
27 Data logger Yes
28 Flash Type 64Mb Serial Flash
29 Data Type
Data Type Records
1：UTC Time, Longitude, Latitude Greater than 360,000
2：UTC Time, Longitude, Latitude, Altitude Greater than 300,000
3：UTC Time, Longitude, Latitude, Altitude, Velocity Greater than 260,000
4：All Data Greater than 80,000
Bluetooth
Bluetooth Operating
Frequency
2401~2479 MHz
Bluetooth certified BT 2.0
Bluetooth UART port
support data rate
115200
Bluetooth distance ≧ 10m
1.6 Logger function
MBT-1100 provides “Log On Demand.” (LOD) as factory default, the
receiver will log the position only when the Green LED glowing (GPS fix)
and push the power button when the 3 LEDs (Green, Blue, Red) blink
then the current position will be saved.
If the Green LED blinks then MBT-1100 will not save the current position.
There are two modes for the log function, one is “log by push button only
(LOD)”, the other is “log by time”, and default is LOD only. If you need
MBT-1100 log the position by time interval, you should use Data
Download utility to change the log method to log by time. Please read