Radio Shack Trunk Mount - Manual (Page 7)

7
CONNECTING YOUR AUTOSOUND SYSTEM
Low Level Input Connections
You can connect your autosound system’s low-level phono output jacks to the
amplifier’s
LOW INPUT phono jacks.
Note: For a cleaner, less noisy signal transfer between your autosound system
and the amplifier, the amplifier’s
LOW INPUT phono jacks are gold-plated.
For the best results, use shielded audio cables, such as Cat. No. 42-2368 (not
supplied). If your autosound system has only two phono outputs, you will also
need two shielded Y-adapter cables, such as Cat. No. 42-2435 (not supplied).
1. Temporarily place the amplifier as close as possible to the selected mount-
ing location.
2. If your autosound system has four phono outputs and you are using four
speakers, connect the autosound system to the amplifier using audio cables
as follows: front-left to
FRONT L , front-right to FRONT R , rear-left to REAR L ,
and rear-right to REAR R :
12-1976.fm Page 7 Tuesday, July 13, 1999 10:01 AM