Raymarine ST60 - Manual (Page 12)

2 ST60 Rudder Angle Indicator Instrument Owner’s Handbook
Display illumination
When the instrument is first powered up, the display illumination is set to its
lowest (courtesy) level, to facilitate initial access to the keys.
To adjust the level of display illumination:
1. Hold down the
key for approximately 1 second, to enter the illumination-
adjust mode.
2. There are four preset illumination levels from a courtesy level to full bright-
ness. Momentarily press the key to cycle through these levels until you
reach the level you want. The selected level is transmitted to all other instru-
ments on the SeaTalk bus.
3. Press any other key to leave the illumination-adjust mode.
Note: The display will return to normal operation 7 seconds after the last key press.
1.3 Remote control
The ST60 Rudder Angle Indicator does not support the SeaTalk remote control
facility. You can only control the instrument with the front panel keys.
D4425-2
Key functions
Used for calibration
(see
Chapter 4, Calibration )
Press for 1 second
to adjust illumination level