Renesas R8C/2 - Manual (Page 2)

1. Installation
Do not connect the E8 emulator hardware until the software support has been installed.
1.
Insert the CD into your computer’s CD-ROM drive. The CD should automatically run the installation program. If
the installer does not start, browse to the RSK directory from the CD root folder and double click on “setup.exe”.
2. The software license agreement will be displayed. Please select the appropriate radio button and click
to continue.
3. Select the software components to install. New users are strongly recommended to accept the default settings.
Click to continue.
4. The destination folder is specified on the next screen. It is recommended to accept the default settings. Click
to continue.
5. Click .
During the installation the Auto-Update dialog will be displayed. Do not configure Auto-Update at this time, it will be
completed in the next section.
Please wait for the installation wizard to complete. This will take a few minutes during which the progress bar will
stop for long periods, this is normal operation.
6. Click
.
2. Auto-update
After the installation has completed.
If the system was rebooted then double click the icon to configure Auto-Update.
Configure the Auto-Update settings dialog to allow your installation to be checked for required updates.
3. Connection
7. Now connect the E8 to J6 on the RSK using the ribbon cable, also connect the LCD module to J8 on the RSK
ensuring that the pin 1 designation corresponds to the marking on the RSK.
8. Connect the E8 emulator to a spare USB port.
The “Found New Hardware” Wizard will appear. Please follow the steps below to install the drivers. Note that
administrator privileges are required for a Windows
TM
2000/XP machine.
9.
Verify the “Recommended” option is selected and click .
10. If using Windows XP, skip to step 12; otherwise click .
11. Click to install the driver.
12. Click to close the wizard.
Note: The Windows driver signing dialog may be displayed. Please accept the driver to continue.