Loading the factory settings – Roland Classic Keyboard C-230 User Manual
Page 35
35
Additional Convenient Functionality
If necessary, you can erase all settings you have saved inside the C-230 and instead load the settings the C-230 contained when
you first bought it.
The following procedure will erase all settings you have
made up to this point.
1.
While holding down the [Function] button, press the
[Chime] button.
The [Function] and [Chime] buttons start flashing.
2.
Release the [Function] and [Chime] buttons.
Be sure to proceed with step (3) within ±10 seconds. If
you wait longer, the [Function] and [Chime] buttons go
dark. After that, you need to return to step (1) if you still
want to load the factory settings.
3.
While holding down the lower part of the [SUBBASS
16] tilt tab, press the [Lute] button.
The [Lute] button starts flashing.
4.
Wait until the [Function], [Chime] and [Lute] buttons
go dark.
5.
Switch off the C-230, wait a few seconds, then switch it
back on again to use the factory settings.
Loading the factory settings
C-230_e.book Page 35 Tuesday, May 19, 2009 10:22 AM